Building needs

To anchore single-sided system to the floor, to mount formwork element, A-frames, scaffolding bracket, etc. Design: Black

The drill hole depth depends on the type of rock and concrete. Security advice: Check tie points for load-bearing capacity before loading (- there are different concrete qualities or types of stone)!

Mount for loop anchor 45°, pigtail anchor and hook anchor. To mount one-sided formwork.

L-shape angled on one side

The damp proof courses protect the masonry from rising moisture. Both sides of the material are ripped and increase the liability to the mortar. Material: Polyethylen, slip-resistant; Thickness: ca. 0,4 mm.

Extremely stable support for the top layer of reinforcement. Corrosion inihibitor Hardwearing, big mats-constraint Conforms the DBV-handout support Also availalbe with 1 or 2 crossbars

MPA certificated! Masonry collars from TPE-Themoplastic Elastomer Application area: The sealing collar is used whenever a water-tight lead-through of pipe lines through foundation slabs, walls, and masonry is required. The sealing...

Square bar spacer made of fibre reinforced concrete. Manufactoring length 100 cm. Also available in different lenghts (e.g. 18, 25 and 33).

Gas and water tight sealing for drill holes, tubes, etc. Rubber insert made of EPDM, press plates made of stainless steel V2A completly gastight and watertight pressing water 2.5 bar (30 m WS) radon tight KTW/W270 drinking water - quality

For non-pressing water 1.5 bar Rubber insert made of EPDM, press plates made of stainless steel V2A completly gastight and watertight NBR rubber insert on request

For pressing water 5 bar Rubber insert made of EPDM, press plates made of stainless steel V2A completly gastight and watertight NBR rubber insert on request

Annular seal Basic 1 made of stainless steel, V2A (material no.1.4301) Seal width 20 mm for non-pressing water up to 1.5 bar completely gastight and watertight built-in torque control EPDM rubber insert DIVIDING THE RING SEAL BASIC 1 To...