Building needs

Tested formwork oil suitable for all formworks. Good degradable with certificate Mixture of mineral oil and plant-based oil Apply a thin layer for best effect with protection of the formwork. No cleaning of the formwork neccessary....

Sylomer sound bearing bearing type SR 28 Area of application Pressure load Deformation Form factor dependent, the specified values apply to form factor q = 3 Static area of application (static loads) up to 0,028 N/mm² approx. 7 % Dynamic...

Sylomer sound bearing bearing type SR220 Area of application Pressure load Deformation Form factor dependent, the specified values apply to form factor q = 3 Static area of application (static loads) up to 0,22 N/mm² approx. 10 % Dynamic...

Sylomer sound bearing bearing type SR 18 Area of application Pressure load Deformation Form factor dependent, the specified values apply to form factor q = 3 Static area of application (static loads) up to 0,018 N/mm² approx. 7 % Dynamic...

Sylomer sound bearing bearing type SR110 Area of application Pressure load Deformation Form factor dependent, the specified values apply to form factor q = 3 Static area of application (static loads) up to 0,110 N/mm² approx. 10 %...

Comply with the requirements for covering vertical reinforcement bars in accordance with § 6 (4) BauV. The protective cap is made of special plastic and it is made in one piece. The cap has a steel insert for optimal safety. The...

The pressure cones are attached to the spacer tube. After concreting, the pressure cones are removed from the concrete and can be reused.

The RS20 and RS21 badges are mounted on an unplastered wall and are unmistakable documents for all craftsmen.

Sylomer impact sound bearing SR 450 Area of application Pressure load Deformation Form factor dependent, the specified values apply to form factor q = 3 Static area of application (static loads) up to 0,45 N/mm² approx. 10 % Dynamic area...

Tube outside roughened. (Asbestos-free) Lenght 1,25m

for every annular seal with a sealing width of 40 mm

spacers made of impact-resistant material for breaking edges on square columns and beams, but also for decorating large exposed concrete parts. Provide nail holes every 10-15 cm for fastening.