Building needs

Plastic plugs (colour gray) to close the spredaer after form removal.

Concrete-gray made of elastic plastic

Sylomer impact sound bearing SR 450 Area of application Pressure load Deformation Form factor dependent, the specified values apply to form factor q = 3 Static area of application (static loads) up to 0,45 N/mm² approx. 10 % Dynamic area...

Comply with the requirements for covering vertical reinforcement bars in accordance with § 6 (4) BauV. The protective cap is made of special plastic and it is made in one piece. The cap has a steel insert for optimal safety. The...

Ball head anchors are used to transport prefabricated parts. K2.5 load group = 2.5 tons easy to weld and 3-fold safety against material failure.

suitable for 3.0-5.0 tons and stop at the crossbar.

The fiber cement wall sleeves are available for immediate delivery from DN 80 to DN 600. The tube is smooth on the inside and roughened on the outside. Because the undulating outside connects with the concrete no water circulation occurs.

WELLO , the lining tube made of PE with an all-round swelling coating. The tube is smooth inside. The undulating outside clings to the concrete. Two swelling tapes applied around the center also prevent water from entering the structure...

Reduzierstück von Durchmesser [Ø] 26 mm auf 22 mm. Das Reduzierstück für die Wassersperre kann für Kunststoff- oder Faserbeton-rohre verwendet werden. Werkstoff: HDPE / PP

CEM805 (Kartusche 290 ml) ist ein einkomponentiger, geruchsneutraler Dicht- und Klebstoff auf der Basis eines MS-Hybrid Polymers. Er enthält keine Lösemittel, ist silikon- und isocyanatfrei, vernetzt neutral, ist anstrichverträglich und...

The joint tape roll is made of galvanized stell with a both sided polymer-bitumen coating. The coating is protected by a paper which is lenghtwise split for easier usage. Roll á 20 lfm

Formwork stop made of fibreglass. Pins Ø: 10 mm; Length: 100 mm ADVANTAGES: Non-corrosive High strength and stable Chemical resistance Fast and easy installation INSTALLATION: Mark the position of the formwork with a snap line. Drill...