Building needs

For more stability light angle. The sealing plate is made of galvanised steel and has polymer bitumen coating on both sides (Adhesive coating).

Type 2: Reusable profile strip. When stripping the formwork, the rail comes out with the formwork.

The VIBA-Flex joint sheet metal with mounting foot is coated in a special polymer-bitumen coating. The coating is protected through a tearproof protection paper.

for every annular seal with a sealing width of 40 mm

Rainfall drips off at the drip edge without hitting the underside of the surface or the vertical wall.

The RS20 and RS21 badges are mounted on an unplastered wall and are unmistakable documents for all craftsmen.

Sylomer impact sound bearing SR 450 Area of application Pressure load Deformation Form factor dependent, the specified values apply to form factor q = 3 Static area of application (static loads) up to 0,45 N/mm² approx. 10 % Dynamic area...

Cross clamps in different designs for grounding strap / wire combination

The P-Cable Basic HRD annular seal is available in various designs. The following product identification is used: SG x (number of holes) / y-z (area in which the hole can be adjusted)

Type blank Other lengths and dimensions on request.

Steel quality: Stainless steel Other lenghts and dimensions on request!

Made of fibre concrete with pimples for horizontal mats reinforcement. There are only a few support points due to nubby surface.